Skip to Content

RIP version 2 on CISCO PACKET TRACER

  • Post reply
1 reply [Last post]
Tue, 2012-07-24 12:35
nutsgwari
nutsgwari's picture
Offline
Joined: 2012-07-24
Posts: 1

hello sir, 

just done with Dynamic Routing from ICND1 CBTnuggets lesson.. and must say it was awesome experience... i just loved the way u clarified everything... 
But one problem i always had is.. i am using Packet Tracer 5.2.3 so, most of the commands are not supported by the Router Models in PT.
Again when i Started Doing Dynamic Routing even then i had a problem doing same..
when i executed command :
Show ip route --> it doesnt shows routed networks in there.. Help Please... next lesson is NAT/PAT  , am excited to learn that.. So, plz help me out.

No votes yet
Top
  • Quote
Wed, 2012-07-25 18:10
#1
reymund.oyong
Offline
Joined: 2012-07-25
Posts: 2

I used to use Packet tracer when I was studying CCNA. RIP version 1 and version 2 should work fine. If you don't see RIP routes when you use show ip route, I believe there is a configuration problem. I have RIPv2 configuration quick guide using packet tracer that may help you. If you are interested, let me know. ;)

Top
  • reply
  • quote

You must be signed in to contribute to the forums.

Not registered? Click here to create an account. It only takes a minute and it's free!

Already signed up? Click here to login.



Dr. Radut | forum